Back to topping-out-ceremony     Forward to cockpit The Pedals: The pedals are attaches at the master brake cylinder. Attachment of the clutch cable. Attachment of the gas cable. Attachment of the manipulator of the master brake cylinder. The whole pedals in the installed condition. Note! Don't push the brake pedal now! Without brake fluid and the attached brake tubes the brake can be pushed much deeper than under normal conditions. A rubber inside the master brake cylinder can invert itself and ruin the brake cylinder thereby! The unit is put as shown at the photo from the interior to the outside of the body and now fastened with the two screws at the engine compartment. Now the brake fluid container can be attached. The gas cable at the front panel. Put the small plug in the opening and turn it 90 degrees, overlay the spring and lock the whole thing with the pin. How it looks like when installed. The clutch clearence is adjusted with the help of these two nuts in the engine compartment. The bowden cable is fixed with a hook at the front exaust silencer. An aluminium cover protects the cable from heat. Back to topping-out-ceremony     Forward to cockpit